Table of Contents
Advertisement
Stopping the Machine
To stop the machine, move the motion-control levers to
N
and outward to the P
EUTRAL
blade-control switch, move the throttle to the S
and turn the ignition key to O
ignition switch.
WARNING
Children or bystanders may be injured if they
move or attempt to operate the mower while it is
unattended.
Always remove the ignition key and move the
motion-control levers outward to the P
when leaving the machine unattended, even if just
for a few minutes.
Adjusting the Height-of-Cut
Note: The transport position is the highest height-of-cut
position at 115 mm (4-1/2 inches) as shown in
position, disengage the
ARK
LOW
. Remove the key from the
FF
ARK
Figure
Figure 17
Adjusting the Anti-Scalp
Rollers
position,
107 cm (42-inch) Mower Decks Only
Whenever you change the height of cut, adjust the height
of the anti-scalp rollers.
Note: Adjust the anti-scalp rollers so the rollers do not touch
the ground in normal, flat mowing areas.
1. Disengage the blade-control switch (PTO) and engage
the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position
position.
3. Adjust the anti-scalp rollers to 1 of the following
positions:
•
Upper hole—use this position with the mower deck
in the 63 mm (2-1/2 inch) and below height-of-cut
positions
17.
•
Lower hole—use this position with the mower
deck in the 76 mm (3 inch) and above height-of-cut
positions
1. Anti-scalp roller
2. Lower hole—the mower
deck in the 76 mm (3 inch)
and above height-of-cut
positions
3. Flange nut
Adjusting the Anti-Scalp
Rollers
127 cm (50-inch) Mower Decks Only
Whenever you change the height of cut, adjust the height
of the anti-scalp rollers.
Note: Adjust the anti-scalp rollers so the rollers do not touch
the ground in normal, flat mowing areas.
22
(Figure
18).
(Figure
18).
g019929
Figure 18
4. Upper hole—the mower
deck in the 63 mm
(2-1/2 inch) and below
height-of-cut positions
5. Bolt
4
5
Hide quick links:
Advertisement
Table of Contents
