Table of Contents
Advertisement
Premaintenance
Procedures
Removing the Hood
1. Release hood latches (Figure 42) and pivot open the
hood.
Figure 42
1. Hood latch (2)
2. Remove the cotter pins securing the rear hood
brackets to the frame pins and lift off the hood.
Lubrication
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. If the machine is operated under normal
conditions, lubricate all bearings and bushings after
every 50 hours of operation or immediately after every
washing.
The grease fitting locations and quantities are as follows:
• Brake shaft pivot bearings (5) (Figure 43)
• Rear axle pivot bushings (2) (Figure 44)
36
Figure 43
Figure 44
Advertisement
Table of Contents
