Connecting Your Speakers - Onkyo HT-S3100 Instruction Manual

Connecting Your Speakers

Speaker Connection Precautions
Read the following before connecting your speakers:
• You can connect speakers with an impedance of
6 ohms or higher. If you use speakers with a lower
impedance, and use the amplifier at high volume lev-
els for a long period of time, the built-in protection
circuit may be activated.
• Disconnect the power cord from the wall outlet before
making any connections.
• Pay close attention to speaker wiring polarity. In other
words, connect positive (+) terminals to only positive
(+) terminals, and negative (–) terminals to only nega-
tive (–) terminals. If you get them the wrong way
around, the sound will be out of phase and will sound
unnatural.
• Unnecessarily long, or very thin speaker cables may
affect the sound quality and should be avoided.
• Be careful not to short the
positive and negative wires.
Doing so may damage the AV
receiver.
• Don't connect more than one
cable to each speaker termi-
nal. Doing so may damage the
AV receiver.
• Don't connect one speaker to several terminals.
Subwoofer
Purple
Gray
Blue
Surround Surround
right left
speaker speaker
Connecting Speaker
The AV receiver's positive (+) speaker terminals are
color-coded for ease of identification. (The negative (–)
speaker terminals are all black.)
Speaker terminal
Front left
Front right
Center
Surround left
Surround right
Subwoofer
1
Strip 3/8" (10 mm) of insu-
lation from the ends of the
speaker cables. (Supplied
speaker cables are already
stripped.)
2
While pressing the lever, insert
the wire into the hole, and then
release the lever.
Make sure that the terminals are
gripping the bare wires, not the
insulation.
The following illustration shows which speaker should
be connected to each pair of terminals.
Red
Green
Center speaker Front right
speaker
Color
White
Red
Green
Blue
Gray
Purple
3/8" (10 mm)
White
Front left
speaker
21