Advertisement
Caution
• A mounting screw's ability to support a
speaker depends on how well it's
anchored to the wall. If you have
hollow walls, screw each mounting
screw into a stud. If there are no studs,
or the walls are solid, use suitable wall
anchors. Use screws with a head
diameter of 5/16" (9 mm) or less and a shank diameter of
1/8" (4 mm) or less. With hollow walls, use a cable/pipe
detector to check for any power cables or water pipes
before making any holes.
• Leave a gap of between 3/16" (5 mm) and 7/16" (10 mm)
between the wall and the base of the screw head, as
shown (We recommend that you consult a home
installation professional).
Enjoying Home Theater
The Home Theater means that you can enjoy surround
sound with a real sense of movement in your own home —
just like being in a movie theater or concert hall.
.
1 Front left and right speakers (SKF-591)
They should be positioned facing the listener at about
ear level, and equally spaced from the TV. Angle
them inward slightly so as to create a triangle, with
the listener at the apex.
2 Center speaker (SKC-591N/SKC-591)
Position it close to your TV (preferably on top)
facing forward at about ear level, or at the same
height as the front left and right speakers.
3 Surround left and right speakers (SKR-590)
Position them at the sides of the listener, or slightly
behind, about 2 to 3 feet (60 to 100 cm) above ear
level. Ideally they should be equally spaced from the
listener.
4 Subwoofer (SKW-593/SKW-591)
The subwoofer handles the bass sounds of the LFE
Wall
(Low-Frequency Effects) channel and bass from the
satellite speakers when a crossover is specified. The
volume and quality of the bass output from your
subwoofer will depend on its position, the shape of
your listening room, and your listening position. In
3/16" to 7/16"
general, a good bass sound can be obtained by
(5 to 10 mm)
installing the subwoofer in a front corner, or at one-
third the way along the front wall, as shown.
1/3 of wall
position
4
1
2
3
Corner
position
3
Connecting the Speakers
Speaker Connection Precautions
Read the following before connecting your speakers:
• Turn off your receiver before making any connections.
• Pay close attention to speaker wiring polarity.
Connect positive (+) terminals to only
positive (+) terminals, and negative (–)
terminals to only negative (–) terminals. If the
speakers are wired incorrectly, the sound will be out of
phase and will sound unnatural.
• Be careful not to short the positive and negative wires.
Doing so may damage your amp.
Powered
Front right
subwoofer
speaker
Center speaker
Red
*
Using the supplied
RCA cable, connect
the subwoofer's
LINE INPUT to
your AV receiver's
SUBWOOFER
PRE OUT jack.
Surround
right
speaker
Front left
speaker
Green
White
Blue
Gray
Surround
left
speaker
Advertisement
