Using The Tuner; Listening To The Radio - Onkyo HT-S3100 Instruction Manual

Using the Tuner

Listening to the Radio

STANDBY/ON
STANDBY
A SPEAKERS B TONE + STEREO LISTENING MODE DISPLAY DIGITAL INPUT
PHONES
MULTl CH DVD VIDEO 1/VCR VIDEO 2 VIDEO 3
With the built-in tuner, you can enjoy AM and FM radio
stations. You can store your favorite stations as presets
for quick selection.
1
Use the [TUNER] input selector
TUNER
button to select either AM or FM.
In this example, FM has been selected.
Band
(Actual display depends on country.)
AM Frequency Step Setup
(not North America and Europe)
Here you can specify the AM frequency step used in
your area. When this setting is changed, all radio presets
are deleted.
1 Press the [SETUP] button to dis-
play "0. Hardware Setup," and
then press [ENTER].
2
Use the Up and Down [
buttons to select "AM Freq," and
then use the Left and Right
[ ]/[ ] buttons to select:
10 kHz: Select if 10 kHz steps are
used in your area.
9 kHz: Select if 9 kHz steps are used
in your area.
3 Press the [SETUP] button.
Setup closes.
Note:
• This procedure can also be performed on the remote
controller by using its [SETUP] button, arrow buttons,
and [ENTER] button.
TUNING MODE
TUNING
TUNING / PRESET
MASTER VOLUME
ENTER
RETURN SETUP
RT/PTY/TP MEMORY TUNING MODE
CLEAR
TAPE TUNER CD
TUNER SETUP
Frequency
]/[ ]
Tuning into Radio Stations
■ Auto Tuning Mode
1 Press the [TUNING MODE] button
TUNING MODE
so that the AUTO indicator
appears on the display.
2 Press the TUNING Up or Down
[ ]/[ ] button.
TUNING / PRESET
Searching stops when a station is
found.
ENTER
■ Manual Tuning Mode
1 Press the [TUNING MODE] button
TUNING MODE
so that the AUTO indicator disap-
pears from the display.
2
Press and hold the TUNING Up or
Down [ ]/[ ] button.
TUNING / PRESET
The frequency stops changing when
ENTER
you release the button.
Press the buttons repeatedly to change
the frequency one step at a time.
The American model changes FM frequency in 0.2 MHz
steps, 10 kHz steps for AM. For other models it's
0.05 MHz steps for FM and 9 kHz or 10 kHz steps for
AM.
When tuned into a station, the TUNED indicator
appears. When tuned into a stereo FM station, the FM
STEREO indicator appears on the display, as shown.
Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Note:
• You can also use the remote controller's Up and Down
[ ]/[ ] buttons to tune the radio.
TUNED AUTO
FM STEREO
41