Placing A Second Call - Polycom VVX 300 Owner's Manual

Placing a second call

While on a call, you may place that call on hold and make
a second call.
1.
Press the "Hold" key This will place your caller on hold
2.
Press the "New Call" key for a dial tone
3.
Dial the 10-digit phone number or 3-digit extension number
4.
Press the "Send" key or wait for a few seconds to automatically
connect
-The display will now show information about both calls including
the recipient's number and the length of that call.
-Press Up/Down on the directional pad to highlight a call that
you would like to perform an action to
-You can press a line button to switch to the call on that line,
placing the current call on hold.
-On the left side of the screen you will see two phone
symbols. The active call will have the "play" symbol, the call
on hold will have the "pause" symbol.
Soft-Key functions during a second call:
Hold: Places the highlighted call on hold.
Resume: Resumes the highlighted call. If there is an active
call, this will place the currently active call on hold.
End: terminates the current active call. Does not affect calls
on hold.
Transfer: Transfers the highlighted call to specified phone
number or extension. After pressing transfer, dial the desired
number or extension and then press Transfer again to
connect the call. See the Call Management Features section
for further information.
More: Cycles through additional soft-key actions.
Conference: allows you to add a party to that call. While on a
call, press the Conference key, dial your second party, and
when the second party has answered, press the More key
and then Conference to join the calls.
Join: conferences your current active call with the call on hold
Lines/Calls- toggles displaying current calls and the status of
your phone's lines
14