Checking The Hydraulic Lines And Hoses - Toro 30809 Operator's Manual

flow into a drain pan. Install the hydraulic line when
hydraulic fluid stops draining.
Figure 62
1. Hydraulic line
3. Fill the reservoir (Figure 63) with approximately
22.7 liters (6 U.S. gallons) of hydraulic fluid; refer to
Checking the Hydraulic System.
Important: Use only the hydraulic fluids
specified. Other fluids could cause system
damage.
Figure 63
1. Hydraulic fill cap
4. Install the reservoir cap. Start the engine and use all of
the hydraulic controls to distribute the hydraulic fluid
throughout the system. Also check for leaks; then stop
the engine.
5. Check the fluid level and add enough to raise the level
to between marks on the dipstick. Do not overfill.
Checking the Hydraulic Lines
and Hoses
Service Interval: Before each use or daily
Check hydraulic lines and hoses for leaks, kinked lines, loose
mounting supports, wear, loose fittings, weather deterioration,
and chemical deterioration. Make all necessary repairs before
operating.
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• Make sure all hydraulic fluid hoses and lines are
in good condition and all hydraulic connections
and fittings are tight before applying pressure to
the hydraulic system.
• Keep your body and hands away from pin
hole leaks or nozzles that eject high pressure
hydraulic fluid.
• Use cardboard or paper to find hydraulic leaks.
• Safely relieve all pressure in the hydraulic system
before performing any work on the hydraulic
system.
• Seek immediate medical attention if fluid is
injected into skin.
46