Connecting To An Amplifier (To Enjoy The Sound Advantage Of The Dvd Player) - Onkyo DV-S535 Instruction Manual

Connecting to an Amplifier
(To Enjoy the Sound Advantage of the DVD Player)
Although you can reproduce the DVD Player's sound from the TV speakers with the connections on the opposite page,
connecting with an amplifier and subwoofer provide you high quality dynamic sounds.
To reproduce Dolby Digital surround, MPEG1 audio, MPEG2 audio*, and DTS surround sound, you need to connect to an
amplifier with a Dolby Digital, MPEG1 audio, MPEG2 audio*, and DTS decoder respectively.
Before connecting
• Refer to the instruction manual of the amplifier.
• When you connect the DVD Player to the amplifier, be sure to turn off
the power and unplug both units from the wall outlet before making any
connections. Otherwise, the speakers may be damaged.
• Note that one audio/video connection cable is supplied. To use this
cable for the analog connection, leave the yellow plug disconnected.
Making a digital connection with the amplifier
If the amplifier has a Dolby Digital/DTS/
MPEG1/MPEG2*/Dolby Pro Logic decoder
After completing the steps on page 10, set "Audio Out Select"
to "Bitstream" using the menu explained in "Customizing the
Function Settings" starting from page 28. See page 32 for direct
information.
Warning
DO NOT set "Audio Out Select" to "Bitstream" if the amplifier does not
have any of the decoders described above. If you do so, high volume
sound may be output and damage your hearing as well as the
speakers.
If the amplifier doesn't have any of the
above decoders (2 channel digital stereo
type amplifier)
After completing the steps on page 10, set "Audio Out Select"
to "PCM" using the menu explained in "Customizing the
Function Settings" starting from page 28 . See page 32 for direct
information.
Note
• DO NOT set "Audio Out Select" to "Bitstream." See "Warning" above.
• If "Audio Out Select" is set to "Analog 2ch," PCM sounds may not be
reproduced depending on the sound format.
COMPONENT
VIDEO OUTPUT
Y P P
B R
Making the analog connection with the amplifier
If your amplifier has no digital audio input, you can make the
analog connection. If the amplifier has a Dolby Pro Logic
decoder, you can reproduce the Dolby Pro Logic surround
sound.
Note
Make sure that "Audio Out Select" is set to "Analog 2ch" (the
factory setting) to reproduce the Dolby Pro Logic surround sounds
with the analog connection. For details on the "Audio Out Select"
setting, see page 32.
• Connect the plugs securely.
ANALOG OUTPUT
VIDEO OUTPUT
DIRECT TV ( ACOUSTIC
CONTROL
S VIDEO VIDEO
L L
R R
An amplifier with a Dolby Digital/DTS/MPEG1/
MPEG2* decoder or 2 channel digital stereo
To digital
coaxial input
Coaxial connection
cable (not supplied)
DO NOT connect to
the AC-3 RF input
(e.g. of a Dolby Digital
receiver) which is
reserved only for video
disc players.
DIGITAL
OUTPUT
)
COAXIAL OPTICAL
MONO
( DIRECT )
Stereo audio connection cable
An amplifier with no digital connection
* Not applicable for USA and Canadian models
Incomplete
Insert completely
To digital
optical input
Make either connection
depending on the
amplifier's input type.
Optical fiber
connection cable
(not supplied)
: Signal flow
DO NOT connect the power cord
at this time.
Active
Subwoofer
(for powerful bass
sound)
: Signal flow
9