Preparing The Remote Controller - Onkyo DV-S535 Instruction Manual

Preparing the Remote Controller

Inserting the Batteries
1 Open the battery compartment cover.
2 Insert the two R6 (size AA) batteries.
Be sure to match the + and – ends of the batteries
with the diagram inside the battery compartment.
+
3 Close the battery compartment cover.
Notes
• Do not mix new batteries with old batteries or different kinds of
batteries.
• To avoid corrosion, remove the batteries if the remote controller is
not to be used for a long time.
• Remove dead batteries immediately to avoid damage from
corrosion. If the remote controller does not operate smoothly,
replace both batteries at the same time.
• The life of the batteries supplied is about six months but this will
vary depending on usage.
– +
Using the Remote Controller
Point the remote controller toward the remote control
sensor.
STANDBY indicator
(as remote control reception indicator)
The STANDBY indicator lights up each time the
DVD Player receives a signal from the remote
controller. For the other functions of this indicator,
see page 10.
30˚
Notes
• Place the unit away from strong light such as direct sunlight or
inverted fluorescent light which can prevent proper operation of the
remote controller.
• Using another remote controller of the same type in the same room
or using the unit near equipment which uses infrared rays may
cause operational interference.
• Do not put any object such as a book on the remote controller. The
buttons of the remote controller may be pressed by mistake and
drain the batteries.
• Make sure the audio rack doors do not have colored glass. Placing
the unit behind such doors may prevent proper remote controller
operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.
STANDBY/ON
STANDBY
Remote control sensor
30˚
7