Table of Contents
Advertisement
Positioning the Seat
A
C
Positioning the Steering Wheel
The steering wheel has 3 positions for operation and one,
full-up position. Use the full-up position for stepping on and
off the machine and getting out of the seat. When operating
the machine, position the steering wheel where you have the
best control of the machine and are most comfortable.
1. Press your foot onto the steering-column release lever.
2. Position the steering wheel to the desired position
(Figure
16).
A
B
g027751
B
Figure 15
Figure 16
Pushing the Machine by Hand
Important: Always push the machine by hand. Do not
tow the machine, because damage may occur.
This machine has an electric-brake mechanism, and to push
the machine, the ignition key needs to be in the R
The battery needs to be charged and functioning for the
electric brake to be disengage.
Pushing the Machine
1. Park the machine on a level surface, and disengage the
blade-control switch.
2. Set the parking brake, stop the engine, and wait for
all moving parts to stop before leaving the operating
position.
3. Locate the bypass levers on the frame on both sides of
the engine.
4. Move the bypass levers forward through the key hole
and down to lock them in place
g027249
Note: Ensure this is done for each lever.
5. Turn the ignition key on and disengage the parking
brake.
Note: Do not start the machine.
Note: The machine is now able to be pushed by hand.
1. Bypass-lever locations
2. Lever position for
operating the machine
6. When finished, ensure that the key has been returned to
the S
TOP
Note: If the machine fails to move, the electric brake may
still be engaged. If necessary, the electric brake can be released
manually; refer to
22
(Figure
1 2
Figure 17
3. Lever position for pushing
the machine
position to avoid draining the battery charge.
Releasing the Electric Brake (page
position.
UN
17).
3
g017303
37).
Advertisement
Table of Contents
