Starting the Engine
Note: It may be necessary to hold the lever against the stop,
in the C
position, while trying to start the engine.
HOKE
Note: A warm or hot engine may not require choking.
Important: Do not engage the starter for more than
5 seconds at a time. Engaging the starter motor for
more than 5 seconds can damage the starter motor. If
the engine fails to start, wait 10 seconds before operating
the engine starter again.
A
C
E
g027899
Operating the Parking Brake
(SmartPark
™
The parking brake is activated electronically.
Engage the parking brake by one of the following actions:
•
Pressing the SmartPark
(Figure
5).
•
The parking brake engages automatically when the
operator leaves the seat and the traction control pedal is
in the neutral position.
•
The parking brake automatically engages 5 to 6 seconds
after the ignition switch is turned to the O
not already engaged).
Disengage the parking brake by one of the following actions:
B
D
F
Figure 10
)
™
switch to the O
position
N
position (if
FF
•
Tap the traction-control pedal forward or reverse.
•
Pressing the brake switch to the O
Operating the Blades
The blade-control switch, represented by a power take-off
(PTO) symbol, engages and disengages power to the mower
blades. This switch controls power to any attachments that
draw power from the engine, including the mower deck and
cutting blades.
Engaging the Blades
Important: Do not engage the blades when parked in
tall grass. Belt or clutch damage can occur.
Note: Always engage the blades with the throttle in the
F
position.
AST
Disengaging the Blades
1. Control panel
19
position
(Figure
FF
g027901
Figure 11
g027247
Figure 12
2. Blade-control switch—Off
5).