Sony SSC-M183 Service Manual page 26

8. Turn the power of camera off and on again.
9. Click the OK button. The following screen is
displayed. A maximum of two points can be corrected.
10. Align the marker on the spot.
1st point:
Adjust with Address1.
Align the marker on the spot using the upper and left
scroll bars while viewing the monitor.
2nd point:
Adjust with Address2
Align the marker on the spot using the lower and right
scroll bars while viewing the monitor.
m
. The position indicated by the marker on the PC is
approximate. Therefore, adjust the marker using the
monitor screen.
. The smaller square on the PC screen indicates an
approximate range that can be displayed on the
screen. In the area outside of the square, the monitor
is in blank state. Be aware that when the marker is in
this area, you cannot correct the spot.
11. Align the marker on the spot and check if the spot can
be corrected.
Whether the spot can be corrected or not is confirmed
by the checkmark in the checkbox of "Marker" of
"Status" in the lower left corner of the screen, and then
fine adjustment is made.
When the spot is large in size, place a checkmark to
each checkbox of "2 Point" of Address1 and Address2.
Then, the correction range can be indicated by two
points in the lateral direction.
2-8
12. After completion of correction, press the OK button.
The correction data is written into the camera. To stop
the writing, press the Cancel button.
m
. When it is difficult to identify the spot by chroma (color)
noise, place a checkmark in the checkbox of "Chroma
OFF" of "Status" in the lower left corner of the screen.
Then, the spot can be easily identified because the color
output is suppressed.
. When you want to cancel the correction after pressing
the OK button, perform steps 1 to 9 ,and then move the
marker out of the smaller square of the correction screen
and press the OK button.
SSC-M183/M183CE/M188CE/M383/M383CE/M388CE
SSC-DC193/DC193P/DC198P/DC393/DC393P/DC398P