Using Scart (European Model Only); 7.1-Channel Analog Audio Input; Connecting -Compatible Components - Onkyo DV DV-SP506 Instruction Manual

Connecting the DV-SP506—Continued

Using SCART (European model only)

If your TV has a SCART-type AV input, you can use a
SCART cable to connect the DV-SP506 to your TV. This
type of connection carries both the sound and the picture,
so there's no need to connect up the AUDIO OUTPUT
L/R and VIDEO OUTPUT jacks.
• Use a SCART cable (not supplied) to connect the AV
CONNECTOR to an AV input on your TV.
AV CONNECTOR
This connector can output composite video, S-Video, or
RGB video. The default setting is composite, which
should work with all TVs. Consult the manual that came
with your TV to see if you can use one of the higher qual-
ity settings. See page 51 for how to change the video out-
put.

7.1-channel Analog Audio Input

If your AV receiver has a 7.1-channel analog audio
input, connect it as follows.
Connect the DV-SP506's SURR 1 jacks to your AV
receiver's surround input jacks, and connect the
SURR 2 jacks to your AV receiver's surround back
input jacks. The SURR 1 and SURR 2 outputs output
the same signals.
When you make this
connection, set the
SURR MODE switch
to "1+2."
If you use this connec-
tion, the output level
will be reduced by
3 dB (i.e., the volume
level will be reduced
slightly).
28
TV
SCART
Connecting -compatible
Components
REMOTE
CONTROL
REMOTE
CONTROL
• The remote controller supplied with Onkyo AV
receiver or amplifiers can be used to control the
DV-SP506.
• The function of the upper and lower
are the same. Connect to either one.
• To use , in addition to an
also make an analog audio connection (RCA) between
the DV-SP506 and your other
nents.
• If you're using RIHD, do not connect anything to the
connectors.
D. MIX/FRONT
1 2
IN
L
R
AV receiver
connectors
connection, you must
-capable compo-