Installing Deck And Carrier Frame - Toro 74805 Operator's Manual

4
3
Figure 26
1. PTO Driveshaft
2. Universal Joint
14. Move deck and carrier frame away from traction unit.
Important Remove drive shaft from gearbox shaft if
you do not hook up a deck immediately or when putting on
optional attachments.
15. Remove 2 bolts (3/8 in. x 1-5/8 in. (41.5 mm)) and
locknuts (3/8 in.) from universal joint and slide the
driveshaft off gearbox shaft (Fig. 27).
Note: Save all hardware for use when installing mower.
1
Figure 27
1. PTO Driveshaft
2. Universal Joint
3. Gearbox shaft
Installing Deck and Carrier
Frame
Note: Install drive shaft to gearbox shaft if it is not hooked
up. Proceed to step 2 if the driveshaft is hooked up.
1
2
M–4532
3. Gearbox shaft
4. Roll Pin
4
3
2
5
m–3198
4. Bolt, 3/8 x 1-5/8 in.
(41.5 MM)
5. Locknut, 3/8 in.
1. Slide the driveshaft on gearbox shaft. Install 2 bolts
(3/8 x 1-5/8 in. (41.5 mm)) and locknuts (3/8 in.) in
universal joint (Fig. 28).
Note: The gearbox shaft has a spline to correctly align
gearbox and PTO drive shaft. Align the spline and slide the
PTO drive shaft onto gearbox.
1
Figure 28
1. PTO Driveshaft
2. Universal Joint
3. Gearbox shaft
2. Position carrier frame in front of traction unit and place
push arms into clevises (Fig. 29).
3. Install push arms with pivot pin assemblies, aligned
with flat against frame, and secure with hairpin cotters
(Fig. 29).
Note: Pivot pin assemblies and hairpin cotters are part of
traction unit.
2 4
Figure 29
1. Clevis
2. Push Arm
4. Tilt carrier frame into its upright position. Refer to
Tilting the Mower on page 18.
22
4
3
2
5
m–3198
4. Bolt, 3/8 x 1-5/8 in.
(41.5 MM)
5. Locknut, 3/8 in.
1
m–4870
3. Pivot Pin Assembly–flat
4. Hairpin Cotter
3