Toro 74805 Operator's Manual page 21

1
2
2 6
Figure 22
1. Bracket
2. Plenum Cable
3. Washer
4. Nut
5. Tilt carrier frame into its upright position. Refer to
Tilting the Mower on page 18.
6. Place a block, approximately 4 inches high, under the
carrier frame. This will raise the frame vertically.
7. Check to see if tension has been removed from the
spring assemblies. If tension remains add blocks to raise
carrier frame higher. If there is too much tension use a
smaller block (Fig. 23).
8. Remove shoulder bolts (3/8 x 7/8 in.) and locknuts
(3/8 in.) securing spring end plate assemblies to carrier
frame (Fig. 23).
Figure 23
1. Spring Assembly
2. Shoulder Bolt, 3/8 x
7/8 in.
9. Remove the block under the carrier frame.
3
7 8
4 5
m–4851
5. Plenum
6. Plenum cable guide
7. Plenum Latches
8. Blower Housing
3
2
1
m–3209
3. Locknut, 3/8 in.
10. Tilt carrier frame down.
11. Remove the two nuts and bolts that hold the bar for
rubber guard. The bar is under the motion control
levers. Fold the rubber guard onto the footrest (Fig. 24).
4
2
1. Bar
2. Rubber Guard
3. Nut
12. Remove hairpin cotters and pivot pin assemblies from
push arms at traction unit pivot brackets (Fig. 25).
Note: Save all hardware for use when installing mower.
Items 3 and 4 are part of traction unit.
2 4
1. Pivot Bracket
2. Push Arm
Note: Drive shaft remains with traction unit.
13. Drive roll pin through hole in PTO drive shaft to
separate from gearbox shaft (Fig. 26).
21
3
5
Figure 24
4. Machine Panel
5. Screw
1
Figure 25
3. Pivot Pin Assembly–flat
4. Hairpin Cotter
1
m–4858
3
m–4870