Onkyo DV DV-SP405 Instruction Manual page 58

Troubleshooting—Continued
Symptoms
Brightness is unstable
or the picture is noisy?
Chapters or tracks don't
play in the correct
order?
Buttons on the
DV-SP405 and remote
controller don't work?
No sound?
The picture appears
stretched or the wrong
shape?
Audio CD playback
skips or jumps or is
noisy?
An audio CD is loaded
but the DV-SP405 dis-
plays "NO DISC"?
The first track doesn't
play?
Locating a specific
point takes longer than
usual?
Playback starts in the
middle of a track?
Some sections of a
track are skipped?
Playback stops in the
middle of a track?
The DV-SP405 displays
the wrong messages?
58
Causes
The DV-SP405 is connected to your TV
via a VCR or other video equipment and a
copy-protection system is affecting the
picture.
Your TV doesn't support progressive
scanning.
You are using repeat playback, program
playback, or random playback.
Power supply voltage fluctuations and
other anomalies, such as static electricity,
can interfere with normal operation.
The "96 kHz PCM Out" setting is set to
"96kHz".
The "Digital Out" setting is set to "Off".
The wrong input source is selected on
your TV, hi-fi amp, or AV receiver.
The audio cable is not connected properly. Check the audio cable and correct as necessary.
The TV, hi-fi amp, or AV receiver con-
nected to the DV-SP405's audio outputs is
either not on or its volume is turned down.
A DV-SP405 "Digital Audio Out" setting
is set incorrectly.
Playback is paused.
The "TV Screen" setting is wrong.
The loaded audio CD uses copy control.
Remedies
Connect the DV-SP405 directly to your TV
(page 19).
Reset the DV-SP405 to its initial settings
(page 44).
Select normal playback (pages 35–37).
Turn off the DV-SP405, wait five seconds, then
turn it on again. If that doesn't resolve the issue,
disconnect the power cord from the wall outlet,
wait five seconds, reconnect it, then try again.
Change the "96 kHz PCM Out" setting to "96kHz
> 48kHz", or use analog connections (page 45).
Change the "Digital Out" setting to "On" (page 45).
On your TV, hi-fi amp, or AV receiver, select the
input to which the DV-SP405 is connected.
Turn on the TV, hi-fi amp, or AV receiver and set
its volume as appropriate.
Check the "Digital Audio Out" settings and cor-
rect as necessary (page 45).
Resume playback (page 28).
Set the "TV Screen" setting to match the aspect
ratio of your TV (page 46).
Copy-controlled CDs are special discs that don't
conform to the audio CD standard and, therefore,
may not work properly with the DV-SP405.