Onkyo DV DV-SP405 Instruction Manual page 20

Connecting the DV-SP405—Continued
Switching the video output to interlace
using the front panel controls
Switch the player to standby then, using the front panel
controls, press STANDBY/ON while pressing
switch the player back to "Interlace".
• If the player is connected using HDMI, disconnect the
HDMI cable before resetting the player to interlace
output. (If left connected, the HDMI output resolution
will be reset to its default—see Resetting the output
resolution to the default setting with HDMI connec-
tion on page 22.)
STANDBY/ON
Note:
• If you connect a TV that is not compatible with a pro-
gressive scan signal and switch the player to progres-
sive, you will not be able to see any picture at
component out. In this case, switch everything off and
reconnect using the supplied video cable, then switch
back to "Interlace".
Compatibility of this player with
progressive-scan and high-definition TVs
This player is compatible with progressive video Macro
Vision System Copy Guard.
Consumers should note that not all high-definition tele-
vision sets are fully compatible with this product and
may cause artifacts to be displayed in the picture. In case
of 525 progressive scan picture problems, it is recom-
mended that the user switch the connection to the "stan-
dard definition" output (Interlace). If there are questions
regarding our TV set compatibility with this model,
please contact our customer service center.
20
to