Table of Contents
Advertisement
Turn the container selector to choose
8
between the two types of coffee
beans (Fig. 17).
Warning:
B
Whenever you switch between coffee bean
containers or coffee beans, there will always
be traces of coffee left of the previously
ground type of coffee beans. Clean the
grinder funnel after you switch to a new
type of coffee bean to prevent this.
Note:
D
Depending on your taste, you can either
select one of the two types of coffee beans or
a mix of both types.
Press the on/off button on the front of the
9
appliance (Fig. 8).
•
The number of cups starts to flash.
To select the number of cups, turn the knob
10
until the desired number of cups appears on
the display (Fig. 18).
Note:
D
Make sure that the number of cups you select
with the 2-10 cups button is consistent with
the amount of water in the water reservoir.
Please keep in mind that the coffeemaker
uses all the water in the water reservoir. If you
select a number of cups that is smaller than
the amount of water, the coffee becomes
weaker than you intended.
Press in the centre of the knob to confirm the
11
number of cups.
Press the strength select button. (Fig. 9)
12
•
The coffee bean icons start to flash.
Turn the knob to select the desired coffee
13
strength (mild: 1 bean, medium: 2 beans or
strong: 3 beans) (Fig. 10).
•
The display shows the selected coffee
strength.
8
Tip:
E
We advise you to experiment with
the amount of water to find out which
strength you prefer. If you select a number
of cups that is higher than the amount of
water, the coffee becomes stronger. If you
select a number of cups that is smaller
than the amount of water, the coffee
becomes weaker.
Press in the centre of the knob to confirm,
14
Then press in the centre of the knob again to
start the brewing process (Fig. 19).
•
The grinder grinds the required amount of
coffee beans.
Wait until the coffeemaker has stopped
15
brewing before you remove the jug.
Note:
D
After brewing, coffee drips from the filter
basket for several seconds.
5.3 Using pre-ground coffee
If you want to use pre-ground coffee instead of
coffee beans, follow the steps below.
Open the water reservoir lid and fill the water
1
reservoir with the required amount of cold
water. (Fig. 6)
To open the filter basket holder, pull at its tab
2
on the right side of the coffeemaker (Fig. 14).
Take a paper filter (type 1x4 or no. 4) and
3
fold the sealed edges to prevent tearing and
folding. Place the paper filter in the filter
basket (Fig. 15).
Put pre-ground coffee in the paper filter.
4
Note:
D
You can adjust the strength of the coffee to
your own personal taste. For a medium-strong
cup of coffee, use one measuring spoon
(approximately 6g) of ground coffee for each
cup (120ml). For stronger coffee, use 1.5
measuring spoons of ground coffee for each
cup of coffee.
Close the filter basket holder.
5
Put the jug in the appliance (Fig. 7).
6
Press the on/off button (Fig. 8).
7
•
The display lights up.
Advertisement
Table of Contents
