Table of Contents
Advertisement
LOG AND MEDIA PLACEMENT
7. Place left top log (#7) on left rear log (#4) and left front
log (#5) using locating grooves on bottom of #7 and
locating blocks on logs #4 and #5. Figure 32
8. Place right top log (#8) onto right rear (#3) and right
front (#2) logs using locator on bottom of right top log.
Figure 28
Left Top
Log #7
Figure 28 -
Place Right Top Log #8
PLACE THE DECORATIVE ROCK
Optional volanic rock may be placed around the unit on
the fl oor of the fi rebox. Be sure to avoid any areas on the
burner itself.
DO NOT sprinkle volcanic rock on the logs,
around the pilot, or on or near burners. This
may cause sooting. Place volcanic rock only
on the fl oor of the fi replace.
During initial operation of the new heater, new
burning logs and/or rock wool will give off a
paper burning smell and orange fl ames will be
present. Simply open the windows for a few
hours to vent the odor.
20308184
Right Top
Log #8
VFF Vent Free Fireplace System
INSTALL 24", (F,R) HIGHLAND OAK LOGS ON
NATURAL BLAZE BURNER (AVAILABLE FOR
MAJESTIC SYSTEMS ONLY)
1. Place the #1 log (the "chunk") on the grate bar right side
of the burner adjacent to the controls. Figure 29
Figure 29
2. Place front right log (#2) on right pin located on burner
and right grate bar. Figure 30. After placing front right
log, ensure log is fully upright and tilting towards the
back of the burner.
Figure 30
3. Place right rear log (#3) on pin located on rear support
bracket and rest left side of log on front right log. Figure
31. After placing right rear log, ensure log is fully upright
and does not tilt forward. Slide #1 log ember chunk back
to contact right rear log.
Right Rear
Log #3
Figure 31
Ember Chunk
Log #1
Right Front
Log #2
25
Advertisement
Table of Contents
