Table of Contents
Advertisement
3
Figure 53
1. Lens
2. Screws
3. Pull the lens out far enough so you can remove the
bulb socket (Fig. 53).
4. Pull the bulb from the socket (Fig. 53).
Installing the Bulb
1. Push a new bulb into the socket (Fig. 53).
2. Install the bulb socket in the lens and push the lens
into the tractor (Fig. 53).
3. Secure the lens with the two screws removed
previously (Fig. 53).
Servicing the Battery
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Check the electrolyte level in the battery every 25 hours.
Always keep the battery clean and fully charged. Use a
paper towel to clean the battery case. If the battery
terminals are corroded, clean them with a solution of four
4
1
2
m–3321
3. Bulb
4. Socket
31
parts water and one part baking soda. Apply a light
coating of grease to the battery terminals to prevent
corrosion.
Battery size: 12 v, 380 Cold Cranking Amps
Removing the Battery
1. Disengage the PTO, set the parking brake, lower the
attachment lift, stop the engine, and remove the
ignition key.
2. Remove the front grill by pulling it outward toward
you.
3. Remove the battery shield (Fig. 54).
1
8
7
Figure 54
1. Negative cable (black)
2. Positive cable (red)
3. Bolt (2)
4. Washer (2)
6
4
3
5
2
m–5073
5. Locknut (2)
6. Battery shield
7. Hold–down rod
8. Wire tie
Advertisement
Table of Contents
