Check Hydraulic System; Check Tire Pressure - Toro 08884 Operator's Manual

Before Operating
1. Clean the area around the fuel tank cap.
1. Fuel tank cap
2. Remove the fuel tank cap.
3. Fill the tank to about 3 mm below the top of the
tank, (bottom of filler neck). DO NOT OVERFILL.
Then install the cap.
4. Wipe up any fuel that may have spilled to prevent a
fire hazard.
CHECK THE HYDRAULIC SYSTEM
(Fig. 3)
The hydraulic system is designed to operate on Mobil
424 hydraulic oil. The machine's 11 liter reservoir is
filled at the factory with oil. However, check the level of
oil before the engine is first started and daily thereafter.
1. Remove the cap from the hydraulic oil reservoir.
1. Oil reservoir cap
2. Check the level of oil in the reservoir. The oil level
8
Figure 2
Figure 3
should be up to the top of the cone point on the tank
screen.
3. If the oil level is low, slowly fill the reservoir with
appropriate hydraulic oil until the level is up to the
top of cone point on the tank screen. DO NOT
OVERFILL.
Group 1 Hydraulic Fluid (Recommended for
ambient temperatures consistently below 100° F)
ISO type 46/68 anti-wear hydraulic fluid
Mobil
Amoc
International Harvester
Texaco
Shell
Union Oil
Chevron
BP Oil
Boron Oil
Exxon
Conoco
Kendall
Phillips
4. Install the reservoir cap.
IMPORTANT: To prevent system contamination,
clean the top of hydraulic oil containers before punc-
turing. Assure the pour spout and funnel are clean.

CHECK TIRE PRESSURE

Check tire pressure before operating the machine.
Correct air pressure in the front and rear tires is
27–41kPa.
Mobile Fluid 424
Amoco 1000
Hy-Tran
TDH
Donax TD
Hydraulic/Tractor Fluid
Tractor Hydraulic Fluid
BP HYD TF
Eldoran UTH
Torque Fluid
Power-tran 3
Hyken 052
HG Fluid