Lubrication; Changing Crankcase Oil - Toro 08884 Operator's Manual

Before servicing or making adjustments to the
machine, stop the engine and remove the key
from the switch.

LUBRICATION

The Sand Pro has (3) grease fittings that must be lubri-
cated regularly with No. 2 general purpose, lithium-base
grease. Lubricate the front wheel bearing and traction
control linkage after every 25 hours of operation.
Lubricate the steering shaft every 100 hours.
The bearings and bushings that must be lubricated are:
front wheel bearing (Fig ), traction control linkage (Fig.
) and steering shaft (Fig. ).
1. Wipe the grease fitting clean so that foreign matter
cannot be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3 Wipe up excess grease.
NOTE: We do not recommend lubricating the steering
CAUTION
Figure 9
Figure 10
chain unless it becomes stiff because of rust. If the chain
rusts, it may be lubricated lightly with a DRY-TYPE
lubricant.
CHANGING ENGINE OIL AND
FILTER
For new engines, change the oil after the first 8 operat-
ing hours. Thereafter, under normal conditions, change
the oil after every 25 hours of engine operation.
1. Park the machine on a level surface and turn the
engine off.
2. Remove the drain plug and let oil flow into the
drain pan. When oil stops, install the drain plug.
1. Drain plug
2. Oil filter
3. Remove the oil filter. Apply a light coat of clean oil
to the new filter gasket.
4. Screw the filter on by hand until the gasket contacts
Maintenance
Figure 11
Figure 12
13