Changing The Transaxle Fluid; Replacing The Fuses - Toro Twister 12003 Operator's Manual

3. Check the condition of the side electrode, center
electrode, and center electrode insulator to ensure that
there is no damage.
Figure 30
Important A cracked, fouled, dirty or malfunctioning
spark plug must be replaced. Do not sand blast, scrape, or
clean the electrodes by using a wire brush because grit may
eventually release from the plug and fall into the cylinder.
The result is usually a damaged engine.
4. Set the air gap between the center and side electrodes at
0.030 in. (0.76 mm). Install the correctly gapped spark
plug and tighten the plug to 18–22 ft.-lb. (24–30 N m).
If a torque wrench is not used, tighten the plug firmly.
5. Install the spark plug wires.

Changing the Transaxle Fluid

Change transaxle fluid every 800 operating hours or yearly,
whichever occurs first.
1. Position the vehicle on a level surface, set the parking
brake, turn the ignition off, and remove the key.
2. Remove the drain plug from the right side of the
reservoir (Fig. 31) and let the fluid flow into a drain
pan. Install and tighten the plug when the fluid stops
draining.
Note: Dispose of the used oil at a certified recycling center.
2
Figure 31
1. Drain plug
0.030 in.
(0.76 mm)
1
m–4849
2. Level indicator hole
28
3. Fill the reservoir (Fig. 32) with approximately 1-1/2 qt.
(1.4 liters) of SAE 10W30 motor oil or until the oil
level is at the bottom of the level indicator hole
(Fig. 31).
Figure 32
1. Oil fill
4. Start engine and operate to fill system. Recheck oil
level and replenish, if required.

Replacing the Fuses

There are 4 fuses in the electrical system. They are located
beneath the bed in a box on the right hand side of the frame
(Fig. 33).
Low oil light, hour meter
Headlights
Charge circuit
Power point
1
4
Figure 33
1. Charge circuit
2. Headlights
1
10 amp.
10 amp.
25 amp.
10 amp.
(15 amp. max.)
2 3
m–5362
3. Power point
4. Low oil light, hour meter