Table of Contents
Advertisement
5. Insert the new lamp assembly and headlight housing
and align the tabs in the lamp assembly with the slots
in the headlight housing
Note: Take care not to touch the halogen lamp when
installing the new light bulb.
6. Secure lamp assembly by turning it 1/4 turn clockwise
(Figure
40).
7. Connect the electrical connector for the harness to the
connector of the new lamp assembly
8. Connect the battery and close the hood; refer to
Connecting the Battery (page
Replacing the Headlight
1. Disconnect the battery; refer to
Battery (page
33).
2. Open the hood; refer to
3. Disconnect the electrical connector for the harness
from the connector of the lamp assembly
1. Headlight
2. Adjustment screw
3. Opening in the bumper
4. Flat washer
4. Remove the speed clips and washers that secure the
headlight to the headlight bracket
Note: Retain all parts for installation of the new
headlight.
5. Remove the headlight assembly by moving it forward
through the opening in the front bumper
6. Install the new headlight through the opening in the
bumper
(Figure
41).
Note: Ensure the adjustment posts are lined up with
the holes in the mounting bracket behind the bumper.
(Figure
40).
(Figure
34).
Disconnecting the
Raising the hood (page
(Figure
Figure 41
5. Speed clip
6. Harness-electrical
connector
7. Lamp assembly
(Figure
41).
(Figure
7. Secure the headlight assembly with the washers and
speed clips that you removed in step 4.
8. Connect the electrical connector for the harness to the
connector of the lamp assembly
9. Adjust the headlights to direct the beams to the desired
position, refer to
Adjusting the Headlights
40).
Use the following procedure to adjust the headlight beam
position whenever a headlight assembly is replaced or
removed.
1. Turn the starter key to the On position, and turn on
the headlights.
2. At the back of the headlight assembly, rotate adjustment
screws
align the position of the cast beam.
26).
3. Connect the battery and close the hood; refer to
Connecting the Battery (page
41).
41).
36
Adjusting the Headlights (page
(Figure
41) to pivot the headlight assembly and
34).
(Figure
41).
36).
Advertisement
Table of Contents
