Setup; Assembling And Unfolding The Handle - Toro Super Recycler 20382 Operator's Manual

131–4514
1. Warning—read the Operator's Manual.
2. Cutting/dismemberment hazard of hand or foot, mower
blade—stay away from moving parts; keep all guards and
shields in place.
3. Cutting/dismemberment hazard of hand or foot, mower
blade—disconnect the spark-plug wire and read the
instructions before servicing or performing maintenance.
4. Thrown object hazard—keep bystanders a safe distance
from the machine; stop the engine before leaving the
operating position; pick up any debris before mowing.
5. Cutting/dismemberment hazard of hand or foot, mower
blade—do not operate up and down slopes; operate side to
side on slopes; look behind you when backing up.

Setup

1
Assembling and Unfolding the
Handle
No Parts Required
Procedure
WARNING
Assembling and unfolding the handle improperly
can damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when assembling and
unfolding the handle.
• Ensure that the cables are routed to the outside
of the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Raise the rear of the machine housing to its
highest cutting-height setting by moving the 2 rear
cutting-height levers all the way forward. Refer to
Adjusting the Cutting Height (page
2. Attach the handle ends to the machine housing with
2 washers and 2 handle bolts
tighten the handle bolts.
1. Washer
2. Handle bolt
Important: Route the cables to the outside of the
handle (Figure
3. Rotate the handle rearward
5
10).
(Figure 3), but do not
G017457
Figure 3
3. Handle end
3).
(Figure 4).