Taillights; Battery - Toro 73546 Wheel Horse 520Lxi Operator's Manual

Taillights

Bulb: GE 194
Removing the Bulb
1. Disengage the power take off (PTO), set the
parking brake, lower the attachment lift, and turn
the ignition key to "STOP" to stop the engine.
Remove the key.
2. Remove the two screws.
3. Pull the lens out far enough so that you can
remove the bulb socket.
4. Pull the bulb from the socket.
3
Figure 52
1. Lens
2. Screws
Installing the Bulb
Reverse the bulb removal procedure.
4
1
2
m–3321
3. Bulb
4. Socket

Battery

Service Interval/Specification
Check the electrolyte level in the battery every 25
hours. Always keep the battery clean and fully
charged. Use a paper towel to clean the battery case.
If the battery terminals are corroded, clean them with
a solution of four parts water and one part baking
soda. Apply a light coating of grease to the battery
terminals to prevent corrosion.
Battery size: 12 v, 380 Cold Cranking Amps
Checking the Electrolyte Level
1. Park the machine on a level surface. Disengage
the power take off (PTO), set the parking brake,
lower the attachment lift, and turn the ignition
key to "STOP" to stop the engine. Remove the
key.
2. Remove the tractor's front grill by raising the
hood and unscrewing the two screws and
washers securing it in place (Fig. 53). Close the
hood and remove the grill by pulling it out
toward you.
1
Figure 53
1. Grill screw (1 of 2)
3. Remove the battery shield.
Maintenance
m–3558
39