Headlights And Taillights; Positioning The Tilt Steering Wheel; Using The Cruise Control - Toro 73546 Wheel Horse 520Lxi Operator's Manual

Headlights and Taillights

The headlights and taillights are turned on by turning
the ignition key to the LIGHTS position. They can
be turned on even if the engine is not running.
Remove the key when leaving the machine
unattended so that the headlights cannot be turned on
and discharge the battery.
Figure 20
1. Lights
Positioning the Tilt Steering
Wheel
The steering wheel has four tilt locations. Position the
steering wheel where you have the best control of the
machine and are most comfortable.
1. Lift the tilt lever to release the lock (Fig. 21).
2. Move the steering wheel to a comfortable
position; then release the lever to lock it in place.
1
Figure 21
1. Tilt lever
1
m–3312
2
m–3259
2. Steering wheel

Using the Cruise Control

The cruise control is a switch (Fig. 22) on the right
fender that maintains a set traction control position
without foot pressure. The cruise control only
operates when moving forward.
Figure 22
1. Cruise control
Engaging the Cruise Control
1. Begin driving the tractor; refer to Driving
Forward or Backward, page 18. While holding
your foot steady on the traction control pedal,
push the cruise control switch (Fig. 22) to the
"SET" position. This locks the traction control
in position and your foot can then be removed
from the traction control. A constant pedal
position will be maintained.
2. The cruise control has a "speed–up" feature: If
you initially set it to any speed other than full
speed, you can speed up with your foot on the
traction pedal for as long as you wish. When
you release the traction pedal, the pre–selected
cruise speed resumes automatically.
Operation
1
m–3313
21