Fuse - Toro 73546 Wheel Horse 520Lxi Operator's Manual

Changing the Transaxle Filter
Service Interval/Specification
Replace the transaxle filter after the first 50 hours;
then every 200 hours.
1. Drain the oil from the transaxle; refer to
Changing/Draining Transaxle Fluid, page 36.
2. Remove the transaxle filter and wipe the filter
adapter (Fig. 48) gasket surface.
3. Apply a thin coat of new oil to the rubber gasket
on the replacement filter (Fig. 48).
1
Figure 48
1. Transaxle filter
2. Gasket
4. Install the replacement transaxle filter to the
filter adapter. Turn the filter clockwise until the
rubber gasket contacts the filter adapter, then
tighten the filter an additional 3/4 turn (Fig. 48).
5. Fill the transaxle with the proper type of new oil;
refer to Changing/Draining Transaxle Fluid,
page 36.
Cleaning the Power Steering Filter
The power steering filter should be cleaned initially at
50 hours, then at 200–hour intervals thereafter.
Please have your Authorized Service Dealer clean the
filter.
3
2
1256
3. Adapter

Fuse

Service Interval/Specification
The electrical system is protected by fuses. They
require no maintenance. However, if a fuse blows,
check the component and circuit for a malfunction or
short. To replace a fuse, pull it out of the fuse box
(Fig. 49).
1
2
3
4
Figure 49
1. F1; main–30 amp
2. F2; regulator–25 amp
3. F3; dash, interlock, and
cruise control–10 amp
Maintenance
m–3316
4. F4; headlights and
taillights–10 amp
37