Motor Error - Xerox Phaser 6130 Service Manual

Motor Error

Phaser 6130 Color Laser Printer Service Manual
Troubleshooting Procedure Table (continued)
Step Actions and Questions
6 Disconnect J503 from the LVPS.
defeat the front cover interlock and
measure the voltage across P503-1pin
<=> ground on the LVPS.
Does the voltage read about +24 VDC?
Does the error still occur when the
7
power is turned OFF and ON?
The Main Motor has failed.
Applicable Chain Link
042-325: Motor Error
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
MCU Board, PL8.2.13
Main Drive Assembly, PL8.1.2
Troubleshooting Procedure Table
Step Actions and Questions
Check the Imaging Unit for correct
1
installation.
Is the Imaging Unit seated correctly?
2 Does the error still occur?
Error Messages and Codes
Yes No
Replace the Fan Replace the
(page 8-56). LVPS
(page 8-55),
then go to step
7.
Replace the Complete
MCU Board
(page 8-59).
Wiring and Plug/Jack Map References
"Map 1 - Transfer Unit, Control Panel,
Imaging Unit, Dispenser, Fuser" on
page 10-8
"Map 4 - Toner Dispenser Motors, HVPS,
MCU" on page 10-11
Yes
Go to step 3.
Go to step 3.
No
Reseat the
Imaging Unit
and cycle the
power. Go to
step 2.
Complete.
3-67