Xerox Phaser 6130 Service Manual page 150

Error Messages and Codes
3-48
Troubleshooting Procedure Table (continued)
Step Actions and Questions
9 Check the Regi. Sensor (Photo
Sensor) for operation.
Perform the Regi Sensor test:
Mode > Engine Diag > Sensor Test >
Regi Sensor
Does the number on the screen
increase by one, when the actuator
(Regi In Actuator) is operated?
10 Check the Main Motor (Main Drive
Assembly) for operation. During this
check, defeat the Front Cover interlock
switch (HARN ASSY INTERLOCK).
Perform the Main Motor test
(page 4-27): Service Mode
Diag > Motor Test
Does the Motor operate properly?
11 Check the Regi. Clutch (CLUTCH ASSY
DRV) for operation, and Regi Roll Assy
and Metal Regi Roll for rotation
First, start the Main Motor FULL2 test:
Service Mode> Engine Diag > Motor
Test > Main Motor FULL2,
the Regi Clutch test:
Engine Diag > Motor Test > Regi
Clutch.
Does the Regi. Clutch operate
properly, and do the Regi Roll Assy
and Metal Regi Roll rotate?
During this check, defeat the Front
Cover interlock switch (HARN ASSY
INTERLOCK).
12 Reseat the connectors on the Transfer
Unit.
Does the error still occur when
printing?
13 Check the connectors of the Regi
Sensor (Photo Sensor) for connection
Check the connections between the
MCU Board and Regi Sensor (Photo
Sensor).
Are P/J23 and P/J232 connected
correctly?
14 Check the Left Side Harness Assy for
continuity
Disconnect J23 from the MCU Board.
Disconnect J232 from the Photo
Sensor.
Is each cable of J23 <=> J232
continuous?
Yes
Go to step 10.
Service
Go to step 11.
> Engine
> Main Motor.
Go to step 12.
then start
Service Mode >
Replace the
Transfer Unit.
(page 8-41)
Go to step 14.
Go to step 15.
Phaser 6130 Color Laser Printer Service Manual
No
Go to step 13.
Go to step 20.
Go to step 17.
Complete
Reconnect the
connector(s) P/
J23 and/or P/
J232 correctly.
Replace the
Feeder Assy
(page 8-25) or
Left Side
Harness Assy
(page 8-26).