Install Steering Wheel; Install Seat - Toro 30230 Groundsmaster 225 Operator's Manual

Warning
PTO universal shaft is attached to traction unit
frame. DO NOT ENGAGE PTO without first
removing universal shaft or coupling it to a
suitable implement.

Install Steering Wheel

1. Remove steering wheel from seat plate. Remove cap
from steering wheel (Fig. 2).
2. Remove jam nut from steering shaft. Make sure foam
collar and dust cover are on steering shaft (Fig. 2). Slide
steering wheel onto steering shaft.
3. Secure steering wheel to shaft with jam nut and tighten
it to 10–15 ft–lb.
4. Mount cover to steering wheel.
1
3
Figure 2
1. Steering wheel
2. Jam nut
3. Dust cover

Install Seat

The Groundsmaster 225 is shipped without the seat
assembly. Either optional Seat Kit, Model No. 30624 or
30625 must be installed.
Seat Kit, Model No. 30624, Standard Seat
1. Attach "U" springs to seat mounting brackets with (4)
capscrews and flange nuts as shown in figure 3.
4
2
4
4. Foam collar
5. Cover
12
3
1
Figure 3
1. U–spring
2. Seat mounting bracket
2. Secure seat mount assemblies to bottom of seat with (4)
flange head capscrews and (4) spacers (Fig. 3).
Spacers to be positioned between seat and seat mount.
Note: Mount the bracket in the forward set of tapped
mounting holes in seat.
3. Remove hair pin cotter and pull back on locking spring
flap to pivot mounting plate forward (Fig. 4).
1
Figure 4
1. Hair pin
2. Lock spring flap
2
3. Spacer
2
3
3. Seat mounting plate