Casio KL-HD1 User Manual page 22

Error Messages/Display Messages
Message Possible Causes
LABEL LONGER • This message appears
THAN SETTING! when the length of the
OK/CANCEL tape that will actually
be printed is longer
than the specifi ed
tape length.
LOAD A TAPE • You are trying to use
CARTRIDGE the Logo function
12mm OR 18mm while a 6mm (
3
or 9mm ( /
8
cartridge is loaded in
the printer.
LOW BATTERY! • Battery power is low. • Replace the batteries.
NO DATA! • You are attempting
to recall text from
memory when there
is none stored.
NO INPUT • You are attempting
TEXT! a print or preview
operation when no
text is input.
PRINT ERROR! • The tape became
jammed during
printing.
20 EN
Action
• To print, press OK.
• To cancel printing, press
You can then decrease the
number of characters, change
to a longer tape setting, or
select auto tape length.
• Turn off the printer and replace
the tape cartridge with a
1 1
/ ") 12mm ( / ") or 18mm (
4 2
") tape cartridge, and specify the tape
width setting on the printer.
• Store the text in memory and
then try again.
• Input the text and then try
again.
• Turn off the printer and
remove the tape cartridge.
Next, remove the jammed
tape.
• If the steps described above
do not clear the error message,
contact your retailer or your
nearest CASIO service center.
Message
PRINTER NOT
SHUT DOWN
PROPERLY
.
LAST TIME
TOO MANY
CHARACTERS!
3
/ ")
4
TOO MANY
LINES!
Possible Causes
• You removed the • Press any key to initialize the
batteries the last time data that was partially deleted
power was turned on the last time the printer
or while the message powered down.
"PLEASE WAIT"
was displayed, so the
printer did not power
down normally.
• You are attempting • Reduce the number of input
to input more than characters.
80 characters of
text.
• The number of line • Use wider tape or reduce
breaks you input
the number of lines. The
caused the label to
maximum number of lines
exceed the maximum
for each tape width is shown
number of lines for
below.
the tape you are
6mm (
using.
9mm (
• You are attempting
12mm (
to print more than
lines
three lines while an
18mm (
18mm ( 3 / ") tape
4
lines
cartridge is loaded.
• Use wider tape or reduce the
• You are attempting to
number of lines with frame.
print more than two
The maximum number of lines
lines while a 12mm
for each tape width when
( 1 / ") tape cartridge is
2
printing with a frame is shown
loaded.
below.
• You are attempting
to print more than 6mm (
one line while a 6mm
9mm (
1 3
( / ") or 9mm ( / ")
12mm (
4 8
tape cartridge is
18mm (
loaded.
lines
Action
1 / ") tape...1 line
4
3 / ") tape...1 line
8
1 / ") tape...Up to 2
2
3
/ ") tape...Up to 3
4
1 / ") tape...1 line
4
3 / ") tape...1 line
8
1 / ") tape...1 line
2
3 / ") tape...Up to 2
4