Installing The Front Lift Arms - Toro Reelmaster 2000-D 03431 Operator's Manual

3. Secure each mounting link to the carrier frame with a
capscrew (3/8 x 2-1/4 in.), 2 flat washers, and a locknut,
as shown in Figure 3. Position a washer on each side of
the link when mounting. Torque to 31 ft.-lb. (42 N⋅m).
2
Figure 3
1. Carrier frame
2. Mounting link

Installing the Front Lift Arms

1. Insert a pivot rod into the left lift arm and align the
mounting holes (Fig. 4).
2. Secure the pivot rod to the lift arm with a capscrew
(5/16 x 7/8 in.) and lock washer.
2
Figure 4
1. Lift arm
3. Loosen the top capscrew securing the left
counterbalance arm to the frame (Fig. 5).
1
3
3. Bearing housing cover
1
2. Pivot rod
15
1
2
3
4
5
Figure 5
1. Counterbalance arm
2. Top capscrew
3. Bottom capscrew
4. Lift arm pivot pin
4. Remove the bottom capscrew and nut securing the left
counterbalance arm to the frame (Fig. 5).
5. Rotate the counterbalance arm outward, allowing
removal of the lift arm pivot pin and tipper chain
(Fig. 5).
6. Position the lift arm between the frame members, align
the mounting holes, and install the pivot pin (Fig. 5).
Insert the pivot pin so that the counterbalance arm fits
into the slot in the pin. Do not secure the counterbalance
arm at this time.
7. Secure one end of the lift chain to the lift cylinder pin
with a clevis pin and cotter pin.
8. Secure the other end of the lift chain to the hole in the
lift arm mounting tab with clevis pins and cotter pins.
Use the appropriate hole in the lift arm as designated in
Figure 6.
9. Repeat the procedure on the right-hand lift arm.
Figure 6
7
6
8
5. Tipper chain
6. Lift chain
7. Cylinder pin
8. Lift arm tab
27" Cutting Unit
(Inner Hole)
32" Cutting Unit
(Outer Hole)