Positioning The Seat; Operating The Headlights; Operating The Blade Control (Pto); Setting The Height-Of-Cut - Toro Wheel Horse XL380H 71252 Operator's Manual

Figure 4
1. Brake pedal
2. Lift the parking brake lever (Figure 4) up and
gradually take your foot off of the brake pedal.
Note: The brake pedal should stay in the depressed
(locked) position.
Releasing the Parking Brake
1. Push down on the brake pedal (Figure 4).
Note: The parking brake lever should release.
2. Gradually release the brake pedal.

Positioning the Seat

The seat can move forward and backward. Position
the seat where you have the best control of the tractor
and are most comfortable.
1. Raise the seat and loosen the adjustment knobs
(Figure 5).
Figure 5
1. Adjustment knobs
2. Move the seat to the desired position and tighten
the knobs.

Operating the Headlights

A dash-mounted On/Off switch (Figure 3) controls
the headlights. The lights only shine while the engine is
running and the switch is On.
2. Parking brake lever
Operating the Blade Control
(PTO)
The blade control (PTO) engages and disengages
power to the electric clutch.
Engaging the Power Take Off (PTO)
1. Press the clutch/brake pedal to stop the tractor.
2. Pull the blade control (PTO) to on (Figure 6).
1. Off—disengaged
Disengaging the Blade Control (PTO)
1. Press the clutch/brake pedal to stop the tractor.
2. Push the blade control (PTO) to off (Figure 6).

Setting the Height-of-Cut

Use the height-of-cut lever to raise and lower the
mower to the desired cutting height. You can set
the height-of-cut to one of seven positions from
approximately 1-1/2 to 4-1/2 inches (38 to 116 mm).
1. Park the machine on a level surface.
2. Disengage the blade control (PTO).
3. Set the parking brake.
4. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
5. Pull on the height-of-cut lever on the tractor and
move it to the desired position (Figure 7).
12
Figure 6
2. On—engaged