Using The Burst Setting - HP Photosmart M417 User Manual

Using the Burst Setting

Burst allows you to take up to 4 still pictures as quickly as
possible. The camera then continues taking burst pictures at
a slower rate until you release the Shutter button or the
camera runs out of memory.
1. Press the Timer/Burst
the Image Display.
2. Frame the subject in either the viewfinder or in Live View.
(See Using Live View on page 34.)
3. Press the Shutter button all the way down and hold it. The
camera takes 4 pictures as quickly as possible and
continues taking burst pictures until you release the
Shutter button or the camera runs out of memory.
The Image Display remains off during the burst capture. After
the burst pictures have been taken, each image appears one
at a time on the Image Display.
When Burst is selected, the Burst
Live View screen. The burst setting remains in effect until it is
changed again or until the camera is turned off. The camera
resets to the default Normal burst setting when you turn the
camera off.
NOTE: The burst setting is not available while recording
video clips. You also cannot record audio when using the
burst setting, but you can add an audio clip later (see
Record Audio on page 69). Also, the flash is not
available while using the burst setting.
TIP: To restore the timer/burst setting to what it was when
you last turned the camera off, hold down the
as you turn the camera back on.
HP Photosmart M417/M517 User's Manual
46
button until Burst
icon will appear in the
appears in
button