Continuous Power Mode Jumper - Kohler 8.5RES Service

There are 3 options when the display says SAVE:
Press:
or
or
Now move the master switch to OFF/RESET.
Figure 4-13 Save Mode (after generator set and engine adjustments)
4.6 Continuous Power Mode
Jumper
Generator sets with serial numbers below 2051415
were built with controllers equipped with the continuous
power mode jumper.
Controller Replacement, for additional information.
Accidental starting.
Can cause severe injury or death.
Disconnect the battery cables before
working
Remove the negative (--) lead first
when disconnecting the battery.
Reconnect the negative (--) lead last
when reconnecting the battery.
46 Section 4 ADC 2100 and DC 2200 Controllers
Downloaded from www.Manualslib.com
To return to the first parameter, coarse voltage adjustment, to check
or change settings before saving. See Figure 4-8.
To save changes.
To discard changes without saving.
"Yes"or "no" flashes when the up or down arrow is pressed and
then the controller exits the configuration mode. The display
returns to the runtime hours.
See TT-1364, ADC 2100
WARNING
on the generator set.
manuals search engine
Disabling the generator set.
cause severe injury or death.
generator set or connected equipment, disable the generator
set as follows: (1) Move the generator set master switch to the
OFF position. (2) Disconnect the power to the battery charger.
(3) Remove the battery cables, negative (--) lead first.
Reconnect the negative (--) lead last when reconnecting the
battery. Follow these precautions to prevent starting of the
generator set by an automatic transfer switch, remote
start/stop switch, or engine start command from a remote
computer.
Short circuits. Hazardous voltage/current can cause
severe injury or death. Short circuits can cause bodily injury
and/or equipment damage.
connections with tools or jewelry while making adjustments or
repairs. Remove all jewelry before servicing the equipment.
S A V E
1 P
x x
Y E S
n o
x x x x
Accidental starting can
Before working on the
Do not contact electrical
TP-6196 10/09