Installing The Rear Wheel - KTM 1190 RC8 R Owner's Manual

WHEELS, TIRES

Installing the rear wheel

12.4
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents No braking effect when operating the rear brake.
–
After installing the rear wheel, always operate the foot brake until the pressure point is reached.
x
–
Check the rear hub cush drive.
–
Remove spacer
seal rings.
Long-life grease (
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
–
Install the spacer.
–
Clean the thread of the axle and nut.
B00587-10
–
Clean the mating surfaces of the brake caliper frame and swingarm.
x (
. Clean and grease the mating surfaces of the spacers and the shaft

p. 262)
Replace the wheel bearing.
x
p. 184)
182