Chapter 6 Operating The Pump Motor In The Running Display Mode; The Rpm Mode; Pumping In The Rpm Mode - Omega Engineering OMEGAFLEX FPU5-MT-110 User Manual

Operating the Pump Motor in the
6
RUNNING Display Mode

6.1 The RPM Mode

Figure 6-1 shows the overall block diagram of the RPM Mode in the RUNNING
Display Mode.
In the RPM Mode, you pump fluid at a certain motor speed, without setting the
amount of time you pump or the volume you dispense. The pump motor
measures the time of pumping and volume of fluid dispensed but ignores the
TIME and TOTAL VOLUME settings.

6.1.1 Pumping in the RPM Mode

To pump fluid in the RPM Mode, do the following:
1.
2.
3.
4.
TUBE ID
RPM
STOPPED
DISPLAY
MODE
ACTUAL
START
RPM
STOP
VALUE
Figure 6-1. Block Diagram: Pumping in the RPM Mode
Set up the pump motor for pumping, according to Chapter 3.
Toggle the ON/OFF switch to turn on the unit's power. The display is in the
STOPPED Display Mode. Refer to Figure 6-1.
Either set the tube ID for the tube you are using (following Section 5.3) or
calibrate the tubing (following Section 5.5) before continuing.
Press the RPM key. The display flashes the current RPM setting (xxx rpm).
RPM
Display shows
Displays current
RPM setting
CURRENT
TUBE ID
OR
SETTING
CURRENT
RPM
OR
SETTING
RUNNING
DISPLAY
MODE
xxx rpm
ACTION
TUBE ID SETTING
TO BE USED IN
PUMPING
RPM SETTING
TO BE USED IN
PUMPING
(Refer to Section 5.5)
CALIBRATE
(Optional)
START
STOP
6-1