Attaching A Single Pump Directly To The Motor - Omega Engineering OMEGAFLEX FPU5-MT-110 User Manual

3
Getting Started

3.1.2 Attaching a Single Pump Directly to the Motor

Refer to Figures 3-1 through 3-4.
1.
2.
3.
4.
3-2
Perform ALL of the steps in Chapter 3 before turning the motor on.
Base
Rotor
Shaft
Figure 3-1. Pump in Closed Position
Figure 3-3. Pump in Closed Position
Remove the safety cover if it is on the side of the motor you wish to use. If you
are using one side of the motor only, attach the safety cover to the other side.
Refer to Figure 3-1. Make sure the pump is in the closed position.
Refer to Figure 3-2. Place the blade of a flathead screwdriver in the groove of
the Rotor Shaft. Rotate the Rotor Shaft until its back tab slips into the groove of
the motor shaft. Do not try to force the pump onto the motor until you perform
Step #4.
Refer to Figure 3-3. Swivel the pump back and forth slightly to align the holes
on the back of the Base with the alignment pins on the face of the motor. Press
the pump base up against the face of the motor.
CAUTION
TOP ALIGNMENT
PIN
FACE OF
MOTOR
BOTTOM
ALIGNMENT PIN
ROTOR SHAFT
FLAT HEAD
SCREWDRIVER
Figure 3-2. Aligning the Rotor Shaft
FACE OF
MOTOR
STANDARD
MOUNTING
SCREWS
Figure 3-4. Aligning the Rotor Shaft
MOUNTING
HOLES
MOTOR
SHAFT