Table of Contents
Advertisement
5.
6.
3.1.3 Stacking Two Pumps on One Side of the Motor
FACE OF
MOTOR
FIRST
PUMP
SECOND
PUMP
Figure 3-5. Placing the Second Pump
on Top of the First Pump
1.
2.
3.
4.
5.
6.
Refer to Figure 3-4. With the pump and motor aligned, insert the mounting
screws through the mounting holes in the pump, until they make contact with the
threaded mounting holes in the face of the motor.
Tighten the screws fully with a 9/64 (M3.5) allen wrench.
Perform ALL of the steps in Chapter 3 before turning the motor on.
FACE OF
MOTOR
FIRST PUMP
SECOND
PUMP
FLAT HEAD
SCREWDRIVER
Figure 3-6. Aligning the Rotor Shaft
of the Second Pump
Remove the safety cover if it is on the side of the motor you wish to use. Attach
it to the other side.
Refer to Figure 3-1 through Figure 3-3. Perform Steps 1, 2 and 3 in Section
3.1.2 to put the first pump on the face of the motor.
Refer to Figure 3-1. Make sure the second pump is in the closed position.
Refer to Figure 3-5 and Figure 3-6. Place the blade of the flathead screwdriver
in the groove of the Rotor Shaft of the second pump. Rotate the Rotor Shaft of
the second pump until its back tab slips into the groove of the Rotor Shaft of the
first pump.
Refer to Figure 3-7. With the pumps and motor aligned, insert the optional
LONG mounting screws through the mounting holes in both pumps, until they
make contact with the threaded mounting holes in the motor.
Tighten the long screws fully with a small flathead screwdriver.
CAUTION
Figure 3-7. Securing Both Pumps to
3
Getting Started
LONG
MOUNTING
SCREWS
the Motor
3-3
Advertisement
Table of Contents
