Table of Contents
Advertisement
3-2. Skipping Unused Display Modes
This function selects / deselects modes that should be skipped. Please use this function if you would like to prevent
a mode from being used.
Procedure
1. Choose "Tools" from the Adjustment menu, and press
2. Choose "Mode Skip" from "Tools", and press
3. Use
or
to select the mode to change, and press
4. Select "-" or "Skip" with
to exit.
5. Press
Attention
• You cannot set all the modes "Skip". Set at least one mode to "-".
Note
• Available CAL modes differ depending on each input signal by factory settings.
3-3. Showing and Hiding the EIZO Logo
When the monitor is turned on, the EIZO logo appears on the screen. You can choose to show or hide the display of
the EIZO logo.
Procedure
1. Press
to turn off the monitor.
2. Holding
The "Optional Settings" menu appears.
3. Choose "Logo" from "Optional Settings", and press
4. Select "On" or "Off" with
5. Select "Finish" with
6. Press
.
3-4. Locking Operation Buttons
This function allows you to lock the settings to prevent them being changed.
Procedure
1. Press
to turn off the monitor.
2. Holding
The "Optional Settings" menu appears.
3. Choose "Key Lock" from "Optional Settings", and press
4. Choose "Off", "Menu", or "All" with
Settings
Off (Default setting)
Menu
All
5. Select "Finish" with
6. Press
.
28
Chapter 3 Setting Monitor
or .
down, press
for at least two seconds to turn on the monitor.
or , and press
or .
down, press
for at least two seconds to turn on the monitor.
or , and press
None (All buttons are enabled)
button
All buttons excluding
or .
.
.
.
.
.
.
.
Buttons that can be locked
Advertisement
Table of Contents
