HP ProLiant DL360p Gen8 Maintenance And Service Manual page 67

Connect the chipset SATA cable connector to the chipset SATA controller port on the system
a.
board. The chipset SATA connector on the SATA cable is narrower than the chipset SATA
controller port header on the system board.
Connect the remaining chipset SATA cable connector to the SATA header on the hard drive
b.
cage.
Clip the cable to the power supply air baffle when routing it along the edge of the system board.
8.
Coil the cables behind the hard drive backplane to minimize airflow impact.
9.
Install the access panel
10.
Install the server into the rack.
11.
Remove any installed hard drives
12.
Install a SATA hard drive in hard drive bay 1.
13.
Install hard drive blanks in any empty hard drive bays.
14.
Connect each power cord to the server.
15.
Connect each power cord to the power source.
16.
Power up the server.
17.
("Access panel" on page 27).
("Hot-plug drive" on page 28).
Cabling 67