Display Assembly - Compaq Presario CQ45 Maintenance And Service Manual

Display assembly

Description
14.1-inch, WXGA, BrightView display assembly for use only in computer models with a camera
module (includes microphones)
14.1-inch, WXGA, BrightView display assembly for use only in computer models without a camera
module (includes microphones)
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Disconnect the wireless antenna cables from the WLAN module (see
6. Remove the following components:
a. Keyboard (see
b. Optical drive (see
c. Switch cover (see
Remove the display assembly:
1. Turn the computer display-side up, with the front toward you.
2. Open the display as far as possible.
3. Remove the wireless antenna cables (1) from the hole in the system board and the routing channels
built into the top cover.
62 Chapter 4 Removal and replacement procedures
Battery on page 43).
Keyboard on page 56)
Optical drive on page
Switch cover on page
44)
58)
Spare part number
486728-001
486729-001
WLAN module on page 49).