Demonstrate The Features; Prepare The Remote Control; Set Clock; Turn On - Philips BTM5120 User Manual

Demonstrate the features

• In standby mode, press and hold
front panel for more than 15 seconds to
demonstrate features of this device.
» The features are displayed one by one
across the display panel.
• To turn off the demonstration, press
on the front panel again.

Prepare the remote control

Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
•
Risk of decreased battery life! Never mix different
brands or types of batteries.
•
Risk of product damage! When the remote control is
not used for long periods, remove the batteries.
To insert the remote control battery:
1
Open the battery compartment.
2
Insert the supplied AAA battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.

Set clock

1
In standby mode, press and hold CLOCK
on the remote control for more than two
seconds.
» [CLOCK 24] or [CLOCK 12] hour
format is displayed.
2
Press PRESET/ALBUM
12 or 24 hour format.
on the
/ to select the
3
press CLOCK to confirm.
» The hour digits are displayed and begin
to blink.
4
Repeat steps 2-3 to set the hour and
minute.
Note
•
If no button is pressed in 90 seconds, the system exits
clock setting mode automatically.
Tip
•
You can view clock information in power-on mode by
pressing CLOCK.

Turn on

• Press .
» The device switches to the last
selected source.
Switch to standby mode
• Press again to switch the device to
standby mode.
» The clock (if set) is displayed on the
panel.
Switch to ECO standby mode:
• Press and hold for more than two
seconds.
» The display panel is dimmed.
Note
•
The device switches to Eco Power Standby mode after
15 minutes in standby mode.
•
In Eco Power Standby mode, when you connect a
mobile device to the USB socket, the device switches
to charging mode.
Switch between standby mode
and ECO standby mode:
• Press and hold for more than two
seconds.
EN 7