Raymarine a65 Operation Instructions Manual page 147

Easy Routing Splitscreen Restrictions
The Jeppesen Easy Routing feature Is available
on all Raymarine LightHouse
However some MFD variants are restricted to
displaying in a single page application only when
using this feature.
Fullscreen / Splitscreen
eS Series All variants
gS Series All variants
c12x
e12x
e165
a12x
Building a route using automatic route
generation
Automatic route generation can be used to create an
entire route or can be activated at any time when
building a new route.
From the Chart application:
1. Select Build Route from the chart context menu
or the Navigate menu.
The Build Route menu is displayed.
2. Select Autorouting / Easy Routing so that On
is selected.
Autorouting / Easy Routing can be switched
On and Off at any time during route building.
3. Select the position on the Chart where you want
the route or route leg to start.
4. Select the position on the Chart where you want
the route or route leg to end.
The system will try to automatically calculate the
shortest safe route between the 2 points.
Waypoints, Routes and Tracks
TM powered MFDs.
Fullscreen only
a6x
a7x
a9x
c9x
e7 / e7D
If the automatic route generation completes
successfully the calculated route is displayed.
Waypoints within the route that were calculated
using automatic route generation are assigned
the Marker waypoint symbol.
5. Subsequent route legs can be added by selecting
the next desired location on the Chart.
6. When your route is complete select Finish Build.
The Finish Route Build warning is displayed.
7. Select Exit to complete the route and close the
Build Route menu.
8. Select Follow to immediately start following the
generated route.
9. Select Edit to display the Route in the Route List
147