Connecting The Appliance - Bosch KGV series Instructions For Use Manual

Switch on super cooling, e.g.:
• before placing large quantities of
fresh food in the appliance.
• to cool drinks quickly.
4 super" On/Off button (Fast freezing)
When the button is illuminated, fast
freezing has started. Fast freezing is
used to freeze large quantities of fresh
food and, depending on the quantity,
must be switched on up to 24 hours
before the food is placed in the freezer
compartment. In general,
2-3
hours is
adequate. If the max. freezing
capacity is used, 24 hours are
required. "Fast freeze" cools the
freezer compartment as cold as
possible for 2112 days. The freezer
compartment drops to a very low
temperature. Then the temperature
selected prior to fast freezing is
automatically restored.
Note:
"Fast freeze" may also slightly increase
refrigeration of the refrigerator
compartment.
Note:
At ambient temperatures below
20
oc
and
during "fast freezing" the interior light may
glow at
e.
reduced luminosity when the
door is almost closed (or light switch
pressed). This is quite normal and can be
ignored.
· Ventilation
Fig.
D
The air at the back of the appliance will
heat up. This warm air must be allowed to
fr"eely escape, otherwise the refrigerating
machine must perform more. This raises
electricity consumption. Hence, the
air-inlet and outlet apertures should never
be covered or blocked off!
.. , ,,.,..,.rm;aaJ
t
amaz: •• aa
IN
Connecting the
appliance
After installing the appliance, you should
wait at least
V2
hour before switching on
the appliance. While the appliance is
being transported, the oil in the
compressor may leak into the refrigeration
system.
Clean the interior of the appliance before
using for the first time (see "Cleaning").
The mains socket should be easily
accessible. Connect the appliance to
a
220-240 V/50
Hz AC mains supply at
a correctly installed socket. The socket
must be equipped with a fuse protection
rated 10 A or higher.
If the appliance is to be operated in a
non-European country, check that the
voltage and current type indicated on
the rating plate correspond with the
specifications of your power supply.
The rating plate is situated in the
bottom left-hand side of the appliance.
The mains connection cable may be
replaced by an electrician only.
&
Warning! ·
The appliance may not, under any
circumstances, be connected to
electronic energy-saving plugs
(e.g. Ecoboy; Sava Plug) and to power
inverters which convert direct current
to 230 V alternating current (e.g. solar
energy systems, power networks on
ships).
19