Cleaning The Appliance; Tips For Saving Energy; Operating Noises - Bosch KGV series Instructions For Use Manual

Cleaning
the appliance
• Pull out the mains plug.
• Clean with water and a little detergent.
• Re-insert the mains plug and/or reset
the fuse.
Clean the door seal with water only and
dry thoroughly.
Water used for cleaning must not drip
onto the fascia or light, or run through the
drain hole into the evaporation pan.
Do NOT use abrasive or acidic cleaning
agents or solvents.
The shelves and containers are not
dishwasher-proof; they could warp.
Important care information
for stainless steel
appliances
Use "Chromo!" cleaning agent for
· cleaning stainless steel surfaces.
This cleaning agent is available on the
market under the name "Chromo!" or from
your customer service under
ident-no. 310359 as a 500 ml spray can
or under
ident-no. 166787 as a 50 ml trial can.
To prevent damage to the surfaces, under
no circumstances use abrasive sponges,
metal brushes, sharp-edged implements
or scouring agents. Chemically aggressive
. cleaning agents, such as defrosting
sprays, oven sprays, solvents or stain
removers must not be used either.
The stainless steel surface should be
cleaned in the direction of the grain.
Tips for saving energy
• Install the appliance in a dry, well
ventilated room, but not in direct
sunlight and not near a heat source
(e.g. radiator, cooker, etc.). If required,
use an insulating plate.
• Allow warm food and drinks to cool
down before placing in the appliance!
• Open and close the door as briefly as
possible.
• A layer of hoarfrost in the freezer
compartment will impair refrigeration
of the frozen food and increase power
consumption. Defrost the appliance
regularly.
• Occasionally clean the rear of the
appliance with a vacuum cleaner or
paint brush to prevent an increased
power consumption.
Operating noises
Completely normal noises
Humming noise - refrigerating unit is
running.
nz
Bubbling, whirring or gurgling noises -
refrigerant is flowing through the
refrigeration tubing.
Clicking noise - motor is switching on or
off.
25