Mitsubishi MSZ-HJ25VA Service Manual page 40

Fixing the indoor coil thermistor
There are 2 forms of parts for fixing the indoor coil thermistor.
Clip shape
Position and procedure for mounting the clip-shape part
1. Set the indoor coil
thermistor in the center
of the clip-shape part.
NOTE:
Take care to avoid loss and accidental falling of the clip-shape part inside the unit.
Mount the clip-shape part on the marked position.
Do not pull the lead wire when removing the indoor coil thermistor.
© Copyright 2012 MITSUBISHI ELECTRIC CORPORATION
Distributed in Oct. 2014. No. OBH647 REVISED EDITION-C
Distributed in Dec. 2013. No. OBH647 REVISED EDITION-B
Distributed in Mar. 2013. No. OBH647 REVISED EDITION-A
Distributed in Dec. 2012. No. OBH647
Made in Japan
OBH647C
Holder shape
HEAD OFFICE: TOKYO BLDG., 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN
2. Check the (marked)
mounting position.
New publication, effective Oct. 2014
Specifications are subject to change without notice.
40
When fixing the indoor coil thermistor
to the clip-shape/holder-shape part, the
lead wire should point down.
About the
same length
3.Mount the
clip-shape part.