Cadillac 2016 CTS Manual page 219

218 Driving and Operating
Warning (Continued)
a vehicle ahead. Keep the
entire front of the vehicle
clean.
Visibility is low, such as in
fog, rain, or snow
conditions. ACC
performance is limited under
these conditions.
On slippery roads where
fast changes in tire traction
can cause excessive
wheel slip.
J
(On/Off) : Press to turn the
system on or off. A white cruise
control indicator comes on.
+RES (Resume/Accelerate) :
Press the control up briefly to
resume the previous set speed or to
increase vehicle speed if ACC is
already activated. To increase
speed by 1 km/h (1 mph), press
+RES up to the first detent. To
increase speed to the next 5 km/h
(5 mph) mark on the speedometer,
press +RES up to the second
detent.
SET (Set/Coast) : Press the
control down briefly to set the speed
and activate ACC or to decrease
vehicle speed if ACC is already
activated. To decrease speed by
1 km/h (1 mph), press SET down to
the first detent. To decrease speed
to the next 5 km/h (5 mph) mark on
the speedometer, press SET down
to the second detent.
(Cancel) : Press to disengage
ACC without erasing the set speed
from memory.
(Follow Distance Gap) : Press
to select a following gap time (or
distance) setting for ACC of Far,
Medium, or Near.
Setting Adaptive Cruise Control
If the cruise control is on when not
in use, the cruise on/off control
could get pressed and cruise control
could become active when not
desired. Keep cruise control button
off when cruise is not being used.
Select the set speed desired for
cruise. This is the vehicle speed
when no vehicle is detected in
its path.
ACC will not set at a speed less
than 25 km/h (16 mph), although it
can be resumed when driving at
lower speeds.
To set ACC:
J
1. Press .
2. Get up to the desired speed.
3. Press and release the SET
control.
4. Remove foot from the
accelerator.