Reference Information; Mounting The Sw Hdmi; Tabletop Use; Rack Mounting - Extron electronics SW HDMI Series User Manual

Reference
Information

Mounting the SW HDMI

The SW HDMI switcher can be set on a table, mounted on a rack shelf, or mounted under
a desk, podium, or table.

Tabletop Use

Four self-adhesive rubber feet are included with the SW HDMI. For tabletop use, attach
one foot at each corner on the bottom of the unit, and place the switcher where desired.

Rack Mounting

The SW2 and SW4 HDMI models can be mounted on a 9.5-inch, 6-inch, or 3.5-inch
deep rack shelf. They can also be mounted vertically to the front or back rack support.
The SW6 and SW8 HDMI models can be mounted directly to the rack using the provided
mounting brackets. For mounting procedures, see the instructions provided with the
mounting option.
UL rack mounting guidelines
The following Underwriters Laboratories (UL) guidelines pertain to the safe installation of
the equipment in a rack.
1.
2.
3.
4.
5.
Furniture Mounting—SW2 and SW4 HDMI Only
The SW2 and SW4 HDMI switchers can be mounted under a desk, table, or podium
using an under-desk mounting kit (see the mounting instructions provided with the kit).
Elevated operating ambient temperature — If the equipment is installed in a
closed or multi-unit rack assembly, the operating ambient temperature of the rack
environment may be greater than room ambient temperature. Therefore, install the
equipment in an environment compatible with the maximum ambient temperature
(TMA = +122 °F, +50 °C) specified by Extron.
Reduced air flow — Install the equipment in a rack so that the amount of air flow
required for safe operation of the equipment is not compromised.
Mechanical loading — When mounting the equipment in the rack, ensure that
uneven mechanical loading does not cause a hazardous condition.
Circuit overloading — When connecting the equipment to the supply circuit,
consider the effect that circuit overloading might have on overcurrent protection and
supply wiring. Consider equipment nameplate ratings when addressing this concern.
Reliable earthing (grounding) — Maintain reliable grounding of rack-mounted
equipment. Pay particular attention to supply connections other than direct
connections to the branch circuit (for example, use of power strips).
SW HDMI Series • Reference Information 33